Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. John Deere and its logos are the registered trademarks of the John Deere Corporation. Wagner, Steiger, Versatile, Overseas Harvester, John Deere and circumstances were the primary 4wd brands through the 1960s. It-all were only available in 1969 utilizing the introduction of the 15 Massey Ferguson 4wds. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. Massey-Ferguson ended up being a key player in 4wd marketplace for 24 years. And with such an extensive range of quality products and services available from your Massey Ferguson dealer, there no reason not to keep it genuine. Massey-Ferguson 50H Loader backhoe selling for local farmer Machine will run and drive but is on the rough side selling as is appears to have some Massey Ferguson Model 325 Backhoe Attachment 3pt hitch, 24' bucket, 4 stick controls, outriggers, hoses and couplers to plug into tractor hydraulics. websites are the property of their respective trademark holders. When it comes to your Massey Ferguson machine, the genuine choice for parts and service is the only choice. products and within the Yesterday's Tractor Co. TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. Who have purchased parts and more for their antique tractor from us!Ĭopyright © 1997-2022 Yesterday's Tractor Co. Has been a leading tractor parts supplier on Adapters for Sub-Compact Loaders with Single Center Cylinder Worksaver has developed adapters for single cylinder loaders (Kioti, Kubota, LS, TYM and Mahindra) allowing them to use attachments with the universal skid steer interface, opening the door to a. Minimum measurement between the slots are 5 1\4 inches and Maximum is 6 7\8 inches. Models for John Deere, IH, Kubota, Massey Ferguson, New Holland, Case and others. The 2 bolt mount slots are 9\16 inch & open on the ends. CAPACITY GPM at RPM: 21.5 at 2000, SHAFT DIAMETER: 7\8 inch, SHAFT TYPE: 13 spline, ROTATION: left hand, PORT SIZE INLET: 1-5\8 inch -12 ORB, PORT SIZE OUTLET: 1-5\16 inch -12 ORB, MOUNTING: 2 bolt SAE B, CAPACITY GPM at RPM: 21.5 at 2000, SHAFT DIA: 7\8 inch, SHAFT TYPE: 13 spline, ROTATION: left hand, MOUNTING: 2 bolt SAE B, INLET: 1-5\8 inch -12 ORB, OUTLET: 1-5\16 inch -12 ORB. Ports are located on side of rear housing.